Download  Print this page

Mitsubishi Electric Apricot XEN pentium Owner's Handbook Manual Page 132

Computer.
Hide thumbs

Advertisement

Inside your computer
Jumper J9 - VGA enable
This jumper is provided to allow a hardware disable of the
on-board VGA controller. During normal operation the
jumper clip should be in the position marked EN on the
motherboard. For the majority of systems there will be no
need to move this jumper.
With the jumper in the EN position the on-board video
controller is automatically enabled unless another VGA
compatible controller is found on an expansion card. If a VGA
compatible expansion card is fitted the on-board video
controller is automatically disabled.
If you install a video expansion card and have a problem, with
the system powered down, move the jumper clip to the
position marked DIS.
Jumper J11 - PCI IDE enable
This jumper is provided to allow a hardware disable of the
PCI IDE controller. During normal operation the jumper clip
should be in the position marked EN on the motherboard.
For the majority of systems there will be no need to move
this jumper.
If for any reason you wish to disable the PCI IDE controller,
with the system powered down, move the jumper clip to the
position marked DIS.
Notes
This jumper is only fitted on systems which are equipped with a
PCI IDE controller.
If you do disable the PCI IDE controller you must move jumper
J12 to make the ISA IDE controller the primary controller.
A/16 XEN OWNER'S HANDBOOK

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: