3-2
Installation
Before You Begin
Before you move or change components on the subscriber entertainment system:
Review the installation instructions.
Determine if you are connecting to a standard TV, a composite (baseband) monitor, or a
component monitor.
Verify that you have the necessary cables and other required items.
If the terminal was previously used, clear its hard drive before installing it at a new
subscriber location
Clearing the Hard Drive
On a previously-used cable terminal, delete all recorded programs from the hard drive before
installing it at a new subscriber location. This prevents your new subscriber from viewing
programming they may not have purchased or may not want to see.
To prevent subscribers from accidentally deleting all of their recorded programs, a specific set of
keystrokes is required to clear the hard drive. Having a TV connected is optional.
To clear the hard drive:
1
Start the Diagnostics as described in Section 4, "Diagnostics."
front-panel LED.
2
Using a remote control, within five seconds, press
(On some remote controls, the
If you correctly enter this key sequence in five seconds or less, the hard drive is cleared and
the front-panel LED displays
3
If
is not displayed, re-enter the key sequence in step 2
Clr
If
is displayed, press any other key to reset the terminal, turn it off, and complete the
Clr
clearing process.
DCT6400 Phase III Installation Manual
REPLAY
key may be labeled "
MY DVR
.
Clr
is displayed on the
d 01
,
three times, and
MY DVR
.")
LIST
.
LIVE TV