Using The Diagnostics; Figure 4-1 Example Of The Led For The Main Menu - Motorola DCT6400 Phase III Installation Manual

4-2 Diagnostics

Using the Diagnostics

To use the diagnostics:
1 Ensure that the DCT6400 is installed with the base platform or Thin Client software and
that it is connected to an AC outlet.
Press and immediately press
2
POWER
main menu is displayed on the OSD and "d01" is displayed on the front-panel LED:
> d01 GENERAL STATUS
d02 PURCHASE STATUS
d03 OOB STATUS
d04 INBAND STATUS
d05 UNIT ADDRESS
d06 CURRENT CHANNEL STATUS
d07 UPSTREAM MODEM
d08 CODE MODULES
d09 MEMORY CONFIG
d10 KEYPAD/LED
d11 INTERFACE STATUS
d12 USER SETTING STATUS
d13 PVR/HDD STATUS
d14 DOCSIS
d15 APPLICATION SPECIFIC INFORMATION
d16 INTERACTIVE STATUS (displayed only when Thin Client is running)
E EXIT
Figure 4-1
Example of the LED for the main menu
You can use the following keys to navigate the diagnostics menus:
▲,
Press
CHANNEL CHANNEL
◄,
Press
CURSOR CURSOR
Select E from the main menu or press
DCT6400 Phase III Installation Manual
to enable diagnostic mode. The Diagnostics
SELECT
DIAGNOSTICS
P
MUTE
MUTE
▼, ▲, or
CURSOR CURSOR
►,
or to execute the selected diagnostic.
SELECT ENTER
to exit.
POWER
▼ to select d01 through E.