3-10
Installation
Connecting the IR Blaster
To connect the IR Blaster:
1
Fit the transmitter into the mounting bracket (refer to Figure 3-5).
2
Plug the mini-pin connector into the
Figure 3-6
IR Blaster installed
RF IN 2
CM IN
RF IN 1
CABLE
IN
RPT OUT
3
Remove the adhesive tape cover from the mounting bracket.
4
Position and press firmly to attach the mounting bracket to the IR receiver on the VCR. Be
careful to route the wire so that it does not prevent loading tapes.
Checking the IR Blaster
The IR Blaster is now located near the receiver and the VCR can be controlled through the
terminal. As a final check, operate the VCR using the remote control from various positions in
the room. If the IR Blaster is obstructing the IR receiver on the VCR, move it slightly.
DCT6400 Phase III Installation Manual
jack on the rear panel:
IR
OPTICAL
AUDIO
SPDIF
SPDIF
IN
R
L
RF OUT
IN
R
L
AUDIO
Y
Pb
OUT
IR
S-VIDEO
Refer to text to locate
IR receiver on VCR
VIDEO
ETHERNET
IEEE
OUT
1394
HDMI
SATA
Pr
TV PASS CARD
DCT6400 Phase III
SWITCHED
105-125V
60Hz
4A MAX
500W MAX
VCR