Alarm/Door Bell; Power Fail Transfer - iPECS LIP-8012D User Manual

LIP-7016D/7024D
OPERATION
To set the Wake Up Alarm clock:

Press
TRANS

Dial the Station User Program code 41,

Dial 2-digit hour and minute for alerting,

For a daily (repeating alarm), dial #,

Press
HOLD
To erase Wake-Up:

Press
TRANS

Dial the Station User Program code 42,

Press
HOLD
8.5

Alarm/Door Bell

The system can monitor external Alarm or Door Bell contacts:
Alarm Monitor—should the external contact activate, a unique Alarm
Ring signal and LCD display may be received. To restart the monitor
circuit, the external contacts must be deactivated and the Alarm Ring
signal terminated.
Door Bell—a unique Door Bell Ring (single tone burst) may be received
each time the external contact is activated. A system contact also can
be assigned to act as a Door Open contact.
OPERATION
To terminate the Alarm signal:

Dial 565.
To activate the Door Open contacts:

Lift the handset,

Dial Door Open code, #* and contact number 1-4.
NOTE—Contacts 3 & 4 are only available in the iPECS -300 & 600.
8.6

Power Fail Transfer

When AC power to the system fails, back-up operation may be provided
with back-up batteries or Power Fail Transfer (PFT). When battery back-
up is provided the station will operate normally.
implemented, an SLT is connected to a CO line by the system. This SLT
can be used as any normal SLT, providing service while power is out.
/ ,
PGM
/
.
SAVE
/ ,
PGM
/ .
SAVE
43
User Guide
When PFT is