Spp Function Block; Table 5-71 Spp Dynamic Contained Parameters - Honeywell UMC800 Reference Manual

5.56 SPP Function Block

Description
The SPP label stands for Setpoint Programmer. This block is part of the Setpoint Program category. It
looks like this graphically on the Control Builder.
Dynamic Contained Parameters:
Parameter Index
status 0
save_req 1
sta_req 2
pgm_req 3
seg_req 4
seg_ramp 5
soaksp 6
duration 7
PV 8
adv_req 9
lTimeStamp 16
fGuarSoako 17
fGuarSoakHi 18
8/99

Table 5-71 SPP Dynamic Contained Parameters

Type Use
REAL C
REAL C
REAL C
REAL C
REAL C
BOOL C
REAL C
REAL C
REAL C
BOOL C
LONG C
REAL C
REAL C
RS232 Communications Reference Manual
Function Parameter Index Reference
R/W Description
R block status (see section 5.2 for code list)
R/W save current program request mailbox
R/W state change request
R/W program change request
R/W segment change request
R TRUE if current segment is a ramp
R soak setpoint (eu)
R segment duration (minutes)
R value of PV being controlled by SP program
R/W segment advance request (leading edge)
R Time of last modification
R/W guaranteed soak low limit
R/W guaranteed soak high limit
103