Controls; Tone Control - Classe Audio Sigma SSP Owner's Manual

Controls

The Controls page gives access to settings that are independent of those found in
System Setup and more likely to be changed or used only temporarily.

Tone Control

Setting up the Tone Control involves choosing high- and low-frequency
inflection points, and relative cut or boost for them. The factory default settings
create what is called a tilt control, which tilts the tonal balance either toward
more high and less low frequency for a leaner, crisper sound, or the opposite
direction toward a warmer, fuller sound.
If conventional bass and treble controls are preferred they may be configured
using the Tone Control Setup page as described in the Menu System section.
Press MENU then Tone Control on the touchscreen or an Fkey on the remote
programmed to send the Tone command to access the tone control. The
Tone Control is activated by selecting the Enable box on the touchscreen.
Alternatively, pressing and Fkey programmed for Tone on the remote control
switches to the Tone Control screen and each subsequent press toggles the
control on and off. When the Tone Control is enabled, Tone appears in a box on
the Home page. The Volume up/down buttons on the remote and the volume
knob on the unit are used to increase or decrease the effect of the Tone Control
when in tilt mode. When used as conventional bass and treble controls, the
Boost and Cut buttons on the touchscreen are used for increasing or decreasing
the corresponding Tone Control levels. These controls may also be accessed by
pressing an Fkey programmed for Tone on the remote control and using the
navigation keys. The adjustment range is +/- 6 dB in 0.5 dB increments.
NOTE: To change these parameters, press MENU, then System
Setup, Tone Control Setup.
45