Classe Audio Sigma SSP Owner's Manual page 17

For more information, please contact your dealer and ask about home
automation systems.
RJ-45 - DB9 female adaptor
If your RS-232 control system uses a cable with a male DB9 connector,
you will need to buy or build an adaptor to convert the RJ-45 female to a
DB9 female. Standard RJ45-to-DB9 female connectors come with RJ-45
pins and colors as below. Wire the DB9 adaptor according to this diagram
and table.
RJ-45
Pin-1 = Blue
Pin-2 = Orange
Pin-3 = Black
Pin-4 = Red
Pin-5 = Green
Pin-6 = Yellow
Pin-7 = Brown
Pin-8 = White
Remarks: The Cat 5 cable and connector that is used for the adaptor and
plugs into the rear panel RJ-45 port must use pin-to-pin wiring.
12 CAN-Bus Input and Output
CAN-Bus (Controller Area Network) allows several Classé components to
be connected together for simultaneous operation, such as switching from
On to Standby. Using the CAN-Bus IN and OUT connectors, the Classé
components can be daisy chained together and controlled via the CAN-
Bus interface.
NOTE: The final component in the daisy chain MUST have a
termination plug inserted into the CAN-Bus output.
For more information, refer to the CAN-Bus section found later in this
manual.
DB9
Pin-1 = Brown
Pin-2 = Green
Pin-3 = Yellow
Pin-4 = Orange
Pin-5 = Red
Pin-6 = Blue
Pin-7 = NC
Pin-8 = Black
Pin-9 = White
17