Lip Sync; Video Preview; Configurations; Modes - Classe Audio Sigma SSP Owner's Manual

Lip Sync

The Lip Sync function allows temporary adjustment of audio delay. This is
sometimes necessary due to a problem with the media or as a result of video
processing somewhere in the signal chain causing a video delay. Lip sync allows
a corresponding audio delay to be added to synchronize audio with video. Lip
Sync is a temporary function which is reset to zero upon change of source or
going into/out of standby.

Video Preview

Choosing Video Preview will show the incoming video signal on the
touchscreen. This can be helpful when the SSP is not located in the same room
as the theater, giving a view of the video signal without requiring a local monitor.
It is also a useful troubleshooting tool to determine if a signal is in fact arriving
from the source. Some people just like how it looks, so it may be selected as a
display timeout option (MENU>System Setup>Display Setup). Touching the
display will cause it to revert to touchscreen control. If chosen as a timeout
option, the preview screen will appear after the timeout period has expired.

Configurations

You may create up to six different output configurations to accommodate
preferences like with or without subwoofer, or with subwoofer but configured
for different crossover settings. While these configurations may be associated
with specific sources, they may also be called from the Main Menu page.
Pressing the Configurations button in the Main Menu opens the Configurations
page. Choose the configuration you wish to employ. Note that this configuration
selection will be over-ridden whenever you change or re-select a source with a
different configuration assigned.
To customize configurations, see the Configuration Setup description in the
System Setup section.

Modes

Although each source has a default processing mode associated with it, you
may from time to time wish to choose a different mode. By using this page you
may select from the available processing modes. Modes that are not available to
be used with the current signal type are greyed out. Changing sources will also
change the mode to whatever the Favorite Mode is for that source, so mode
selection should be seen as temporary.
48