Front Panel Controls - Classe Audio CP-50 Owner's Manual

FRONT PANEL CONTROLS

NOTE: All functions (except Display, Gain, and Phase) may be activated directly on the front panel,
or otherwise by the hand held remote control.
DISPLAY:
Three (3) different display brightness levels can be selected (Full/Medium/Low as well as Off).
NOTE: With display set at the OFF position, activating any switches on the front panel or from the
remote control unit will temporarily turn the display to ON at full brightness. The display will
automatically turn back to OFF after approximately 10 seconds from the last change.
GAIN:
The dual gain feature provides the user to set the preamplifier either at REGULAR gain of
18db or LOW gain of 12db. The red indicator "GAIN" appears in the display when LOW gain is
selected.
PHASE:
Phase of the output signal can be switched between inverted (180 degrees phase shift) or
normal non-inverted (0 degree phase shift). The red indicator "PHASE" is shown when the unit is in
the inverted mode.
TAPE
The TAPE button selects the input signal, between the TAPE and SOURCE inputs, which
goes to the main REGULAR and BALANCED output jacks. The red indicator "TAPE" appears
when Tape input is selected. However, the SOURCE signal always appears at the TAPE OUT jacks
and shown in the display.
-9-