Front Panel - Classe Audio Sigma SSP Owner's Manual

1 2 3 4 5

Front Panel

The front panel of the Sigma SSP is shown above. The numbers in the drawing
refer to the descriptions that follow.
1
6 7
MENU
SIGMA SSP
Standby/On Button and Status Indicator LED
Pressing the Standby button puts the SSP into standby mode – a low-
power state which leaves the preamp/processor and outputs inactive. If the
Wake on LAN feature is enabled (see Network Setup) the unit will respond
to system commands via any of the supported control protocols (IR input,
LAN, CAN-Bus or RS-232) from Standby.
If the unit is already in Standby mode, pressing the Standby button fully
powers up the unit.
• LED On (Red) – the SSP is in Standby mode.
• LED turns cyan, then green, then off – the SSP is in the process
of power-up initialization.
• LED On (Blue), indicates the unit is in the operate mode.
• LED Off – the SSP is not getting AC power or the rear panel power
switch is Off.
NOTE: A power-save feature is enabled whenever the Wake on
LAN feature is disabled (see Network Setup). This puts the SSP
into standby after 20 minutes without a signal at its input.
8 9
MUTE
11