The Remote Control - Classe Audio Sigma SSP Owner's Manual

F1 F2 F3
20

The Remote Control

Your Sigma SSP includes a remote control for the most basic operation of
the SSP and transport control of USB and Network-connected devices. The
remote control is shown on the left. The numbers in the drawing refer to the
1
descriptions that follow.
1 Basic Functions
The three buttons along at the top of the remote control groups the
following basic control functions:
3
2
• Mute reduces the audio output of the SSP to the preset mute
level. See the Mute Setup description in the Menu System
section found later in the manual for further instructions.
• Source Select steps sequentially through the available enabled
sources.
4
• Standby switches the SSP between the Standby and Operate
states.
2 Volume Control Buttons
The Volume Up (+) and Down (-) buttons increase or reduce the overall
volume level of the audio output. You can customize selected features of
the volume level. Refer to the Volume Setup description in the Menu System
section found later in the manual for further instructions.
3 Transport Control Buttons
The remote control contains three centrally located buttons, providing
basic transport controls to USB- and Network-connected sources. These
buttons perform the familiar play/pause, scan/skip forward and scan/skip
backward commands.
4 Function Keys (F1 to F3)
The last three buttons on the remote control are the Function buttons,
or Fkeys, which provide additional flexibility to the Sigma SSP remote
control. Think of them as "favorite" buttons that provide direct access to
specific functions or commands not covered by the other buttons. Refer to
the Remote Fkeys description in the Menu System section found later in
the manual for more information.