Clearing Zess Receive-Vlan Ports; Zess Configuration Example - Zte ZXR10 5900E Series User Manual

St- Command
ep
1
ZXR10(config-gei_1/x)#
2
ZXR10(config-gei_1/x)#
<1-4094>
Parameter
< 1-4094>
Example
Command
zess clear receive-vlan {<1-4094>| all}
ZXR10(config)#
Parameter
< 1-4094>
Example
zess receive-vlan <1-4094>
no zess receive-vlan
Paramters Description
Description
control vlan identifier, after configuring, this port will receive
zess flush packet with same control vlan and forward it. It
shall be noted that zess domain used port can't be added into
the same vlan receiving table.
1. Configure port gei_1/4 receive control vlan 2000 flush packet.
ZXR10(config-gei_1/4)# zess receive-vlan 2000
2. Delete port gei_1/4 from the table that control vlan is 2000.
ZXR10(config-gei_1/4)# no zess receive-vlan 2000

Clearing ZESS receive-vlan Ports

To clear ports in receive-vlan table on configuration mode, use the
following commands.
Paramters Description
Description
ZESS control vlan Id.
This example shows how to clear all ports with zess receive-vlan.
ZXR10(config)# zess clear receive-vlan all
ZESS Configuration
Example
The networking figure is as shown in
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 7 ZESS Configuration
Function
This adds port into ZESS
VLAN receiving table.
This deletes port from ZESS
VLAN receiving table.
Function
This clears all ports with zess
receive-vlan in designated vlan.
Figure 21.
71