Zte ZXR10 5900E Series User Manual page 129

Command
cfm ltr-read trans-id <1-4294967295>
ZXR10#
Command
mep< 1-8191> ais {enable |
ZXR10(config-md-ma)#
disable}
Command
mep< 1-8191> lck {enable |
ZXR10(config-md-ma)#
disable}
Command
show md {all|(session <1-16>)}
ZXR10#
Command
show ma {all |( session <1-32>)} md <1-16>
ZXR10#
Command
show mp {all |<1-64>}md <1-16> ma <1-32>
ZXR10#
4. To set ais enabled function , use the following command.
5. To set LCK function , use the following command.
6. To display MD configuration information, use the following
command.
7. To display MA configuration information, use the following com-
mand.
8. To show MP information, use the following command.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 14 Ethernet OAM Configuration
Function
This reads one time LTR route
information. If read one time
arriving a certain MP route,
this route must be discovered
successfully.
Function
This sets ais enabled function.
If client-level command
is configured successfully,
enabling ais will send ais
message backward.
Function
This set LCK function. If
cient-level is configured
correctly, after LCK is enabled,
LCK message will be sent.
backward . After LCK message
is received, mep will lock this
port and stop service flow
forwarding. The local or peer
end LCK is disabled, port will be
unlocked.
Function
This displays MD configuration
information.
Function
This shows all MAs in one MD or
a certain MA once.
Function
This shows MP information.
Only can show a certain MD, one
or all MPs in a certain MA.
119