Zte ZXR10 5900E Series User Manual page 126

ZXR10 5900E Series User Manual (Ethernet Switching Volume)
St- Command
ep
11
ZXR10(config-md-ma)#
12
ZXR10(config-md-ma)#
<1-64><1-8191> direction {down|up}
13
ZXR10(config-md-ma)#
name <mipname>
14
ZXR10(config-md-ma)#
<1-64><1-8191> remote-mac <xxxx.xxxx.xxxx>
15
ZXR10(config-md-ma)#
<1-64>)|all}
16
ZXR10(config-md-ma)#
<1-64>)|all}
17
ZXR10(config-md-ma)#
interface <interfacename>
116 Confidential and Proprietary Information of ZTE CORPORATION
ccm timer-interval < 1-7>
create mep session
create mip session <1-64>
create rmep session
delete mep {<1-8191>|(session
delete mip { (session
assign mep <1-8191> to
Function
This sets MA CCM sending
time interval, representing
CCM sending time interval as
3.33ms,10ms, 100ms, 1s,
10s,1min, 10min respectively.
When MA configures as fast,
only set the value of 1-3.
When MA configures as slow,
only set the value of 4-7.
This creates MEP at MA mode.
MEP of down type and up type
are supported . The whole
device supports 8K MEPs.
This creates MIP at MA mode.
This creates remote-mep.The
MAC address of remote MEP,
the format is 12 hexadecimal
numbers, every four is
separated by ".". The MAC
address can neither be all 0
nor be multicast address and
broadcast address.
Creat at most 64 rmeps in
one MA, the whole device
supports 8K remps.
This deletes MEP, LMEP or
RMEP.
Delete mep command can
delete a designated MEP by
index number and session
number. Also can delete the
current all MEPs in MA by
select all,here MEP includes
RMEP.
This deletes MIP.
When deleting MIP, delete the
designated session number
MIP or delete all MIPs in the
current MA.
The port can be real port or
samartgroup.
When assigning port for MEP,
the MIP that level is lower
than or equal to current MEP
level can't exist on the port
in the same vlan same level.
can't assign port for one MEP
many times.