Link Monitor; Configuring 802.3Ah; Function Configuration - Zte ZXR10 5900E Series User Manual

St- Command
ep
1 set ethernet-oam {enable|disable}
ZXR10(config)#
2
set ethernet-oam <oui>
ZXR10(config)#
3 set ethernet-oam remote-loopback
ZXR10(config)#
timeout <1-10>

Link Monitor

Link monitor function is to do statistics for fault symbols or fault
frames that physical layer receives during fixed time. The driver
has a counter which is always doing the statistics of fault frame,
fault symbol, and total receiving frame number.
reads these information at specific time, then judge and process
according to fault symbol number, fault frame number and total
frame number, detect what kind of event happens and generate
the corresponding event to inform OAMPDU.
There are four types of link event:
1. Link fault symbol period event, count the fault symbol gener-
ated in specific time. Period is defined by symbols number that
physical layer receives in some time.
2. Fault frame event, count the fault frame generated in specific
time.
3. Fault frame period event, count the fault frame generated in
specific time. The period is defined by receiving frame number.
4. Fault frame second accumulated event, count the fault frame
second generated in specific time. Period is defined by time
interval.

Configuring 802.3ah

Function Configuration

Confidential and Proprietary Information of ZTE CORPORATION
Chapter 14 Ethernet OAM Configuration
The platform
Function
This enables Ethernet-OAM in
global configuration mode.
Enable: open global link
Ethernet-OAM function.
Disable: close global link
Ethernet-OAM function.
This sets OUI of Ethernet
OAM.
<oui> is character string
type, the maximum lengthen
is 3.
This sets Ethernet OAM
remote-loopback timeout
interval.
The unit of <1-10> is second.
If the function is not set, the
default value is 3.
109