Enhanced Function Configuration - Zte ZXR10 5900E Series User Manual

ZXR10 5900E Series User Manual (Ethernet Switching Volume)
St- Command
ep
4
ZXR10(config-gei_1/x)#
{enable|disable}
5
ZXR10(config-gei_1/x)#
<1-10> timeout <2-10> mode {active|passive}
6
ZXR10(config-gei_1/x)#
remote-loopback {start|stop}
7
ZXR10(config-gei_1/x) #
link-monitor {{enable|disable}| (symbol-period
(threshold<1-65535> window <1-65535>)|(frame
(threshold<1-65535>) window <1-60>))|
(frame-period (threshold<1-65535>)(wind
ow<1-600000>)|(frame-seconds (threshold
<1-900>)(window <10-900>)) }
8
ZXR10(config)#
ry|link-monitor|satistics}]
St-
Command
ep
1
debug ethernet-oam { all | (interface
ZXR10#
<interface-name>)}
2 debug ethernet-oam packet interface
ZXR10#
<interface-name>{in|out|dual}type{information|n
otify|reqst-varb|resps-varb|org-spec|all} mode
{all-time|(number [100-1000])}
110 Confidential and Proprietary Information of ZTE CORPORATION
set ethernet-oam
set ethernet-oam period
set ethernet-oam
set ethernet-oam
show ethernet-oam [<port>{discove

Enhanced Function Configuration

Function
This enables Ethernet OAM
on port.
Enable: open port link
Ethernet-OAM function.
Disable: close port link
Ethernet-OAM function.
This configures port discovery
mode.
This enables port
remote-loopback.
Start: open link ethernet-oam
remote-loopback function.
Stop: close link ethernet-oam
remote-loopback function.
This configures port link
monitor event mode.
This shows port or global
configuration. The show
command can be used in
other modes.
Function
This opens OAM Debug
function.
If select all, all Debug
information on all ports will
be displayed on foreground.
If select interface, only one
interface Debug information
will be printed on foreground.
This prints Ethernet-oam
packet that is in, out or both
on one interface, the type of
packet can be information
PDU, notify PDU, request PDU
,response PDU and so on.