Enhanced Function Configuration; Instance Configuration - Zte ZXR10 5900E Series User Manual

ZXR10 5900E Series User Manual (Ethernet Switching Volume)
St- Command
ep
1 debug cfm pkt {all | (megid md <1-16>
ZXR10#
ma <1-32> mep <1-8191>) }[{[direction {send
|rcv|alll}],[pkt-nums <10-100>],[time-interval
<4-10000>]}]
2
ZXR10(config-gei_1/x)#
3
ZXR10(config)#
120 Confidential and Proprietary Information of ZTE CORPORATION

Enhanced Function Configuration

cfm-mac <xxxx.xxxx.xxxx>
clear pbt-cfm

Instance Configuration

The three switches use LT function.
The network figure is shown as
F 31 LT F
IGURE UNCTION
The configurations of S1 are as follows:
ZXR10(config)# interface gei_1/1
ZXR10(config－gei_1/1)#switch mode trunk
ZXR10(config－gei_1/1)#exit
ZXR10(config)# vlan 10
ZXR10(config-vlan10)# switchport tag gei_1/1
ZXR10(config-vlan10)# exit
ZXR10(config)# cfm create md session 15 name md15 level 7
ZXR10(config-md)# ma create session 32 name ma1
ZXR10(config-md-ma)#protect vlan
ZXR10(config-md-ma)# primary vlan 10
ZXR10(config-md-ma)# speed slow
ZXR10(config-md-ma)#create mep session 64 1 direction down
ZXR10(config-md-ma)# assign mep 1 to interface gei_1/1
ZXR10(config-md-ma)#
ZXR10(config-md-ma)#create rmep session 2 2 remote-mac
Function
This opens Debug function.
In management mode, print
all receiving and sending
packets of all mep related
ports or only print one or
several receiving, sending or
receiving/sending packets in
one mep selectively (default
is 10), but the time interval
of printing packet can be
4-10000ms.
This configures port MAC.
The mac must be the one that
related to the rack.
This clears all CFM
configurations.
after executing this
command, can't see any
CFM configuration information
by show run.
Figure 31:
C
ONFIGURATION
mep 1 state enable