Data Output; Configuring Ipfix; Basic Configuration; Enabling/Disabling Ipfix Module - Zte ZXR10 5900E Series User Manual

Command
ip stream {enable|disable}
ZXR10(config)#
Command
ip stream cache entries <number>
ZXR10(config)#
Command
ip stream cache timeout active<number>
ZXR10(config)#

Data Output

After collecting data flows in network, network device always out-
puts them to NM server. IPFIX supports to output data to multiple
NM servers. Generally, data are output to two servers: master
server and slave server.
IPFIX adopts template-based data output mode. IFPIX supports to
send template every a few packets or at a certain interval. Packet
template specifies the format and length of packets in subsequent
data flows, and server resolves subsequent data flows according
to template.

Configuring IPFIX

Basic Configuration

Enabling/Disabling IPFIX Module

Setting IPFIX Memory Entries

Setting Aging Time of Active Stream

As for long time active stream, in case it exceeds the set aging
time, this data flow will age out, in minutes, 30 minutes by default.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 16 IPFIX Configuration
Functions
This enables/disables IPFIX
module.
Functions
This sets the number of data
flow entries stored in IPFIX
module, 4096 by default.
Functions
This sets aging time of active
stream.
131