Configuring Qinq; Configuring Subnet Vlan - Zte ZXR10 5900E Series User Manual

St-
Command
ep
1
ZXR10(config-if)#
{normal|uplink|customer|tpid <tpid>}
2
ZXR10(config)#
Example
St-
Command
ep
1
vlan subnet-map session-no<session
ZXR10(config)#
-no><ipaddr><mask> vlan {<vlanid><name>}

Configuring QinQ

switchport <port-list> qinq
show qinq
In figure QINQ TYPICAL NETWORKING, assume switch A's cus-
tomer port is gei_1/1, its uplink port is gei_1/24, switch B's cus-
tomer port is gei_1/1 and its uplink port is gei_1/24.
Configuration of Switch A:
ZXR10_A(config)#vlan 10
ZXR10_A(config-vlan)#exit
ZXR10_A(config)#interface gei_1/1
ZXR10_A(config-if)#switchport qinq customer
ZXR10_A(config-if)#switchport access vlan 10
ZXR10_A(config-if)#exit
ZXR10_A(config)#interface gei_1/24
ZXR10_A(config-if)#switchport qinq uplink
ZXR10_A(config-if)#switchport mode trunk
ZXR10_A(config-if)#switchport trunk vlan 10
ZXR10_A(config-if)#exit
Configuration of Switch B:
ZXR10_B(config)#vlan 10
ZXR10_B(config-vlan)#exit
ZXR10_B(config)#interface gei_1/1
ZXR10_B(config-if)#switchport qinq customer
ZXR10_B(config-if)#switchport access vlan 10
ZXR10_B(config-if)#exit
ZXR10_B(config)#interface gei_1/24
ZXR10_B(config-if)#switchport qinq uplink
ZXR10_B(config-if)#switchport mode trunk
ZXR10_B(config-if)#switchport trunk vlan 10
ZXR10_B(config-if)#exit

Configuring Subnet VLAN

Confidential and Proprietary Information of ZTE CORPORATION
Chapter 1 VLAN Configuration
Function
When configuring QinQ, it
needs to set customer port of
SPVLAN to untagged port and
uplink port to tagged port.
This views configuration
information of QinQ.
Function
This creates a subnet VLAN.
11