Command Bind Switchport - Zte ZXR10 8900 Series Command Manual

Parameter
Description
Example
Command
Function
Command Mode
Command Format
Parameter
Description
Example
Parameter
<ip-address>
<net-mask>
<service-id>
To enter dpi-template configuration mode and bind one rule to dpi-
template 2 (service 2 policy is bound for data flow whose source
IP address is 1.1.1.2/24), execute the following commands:
ZXR10(config)#dpi-template 2
ZXR10(config-dpi-template-2)#bind sip-addr
1.1.1.2 255.255.255.0 service 2

Command bind switchport

This binds port rules in current DPI-template. Command no can
be used to delete this binding.
DPI-template configuration mode with prompt to be
dpi-template)#
bind switchport <slot-id >/< port-id > service <service-id>
Parameter
<slot-id>
< port-id >
<service-id>
To enter dpi-template configuration mode and bind one rule to dpi-
template 2 (sevice 2 policy is bound to port 12 on interface card
locating in slot 1), execute the following commands:
ZXR10(config)#dpi-template 2
ZXR10(config-dpi-template-2)#bind switchport
gei_1/12 service 2
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 7 Configuring DPI Template
Description
It is IP address, expressed in dotted decimal
notation.
It is subnet mask, expressed in dotted
decimal notation.
It is the id of service entry, ranging from 1
to 2047.
Description
It is the slot number where interface card
locates, ranging from 1 to 12.
It is id of port on interface card, ranging from
1 to 48.
It is the id of service entry, ranging from 1
to 2047.
ZXR10(config-
29