Command Bind Service; Command Bind Sip-Addr - Zte ZXR10 8900 Series Command Manual

ZXR10 8900 Command Manual (DPI Volume)
Parameter
Description
Example
Command
Function
Command Mode
Command Format
Parameter
Description
Example
Command
Function
Command Mode
Command Format
28 Confidential and Proprietary Information of ZTE CORPORATION
no bind slot
Parameter
<slot-id>
To enter dpi-template configuration mode and bind one rule with
dpi-template 2 (direct data flow to slot 7), execute the following
commands:
ZXR10(config)#dpi-template 2
ZXR10(config-dpi-template-2)#bind slot 7

Command bind service

This binds service policy in current DPI-template. Command no
can be used to delete this binding.
DPI-template configuration mode with prompt to be
dpi-template-n)#
bind service <service-id >
no bind service
Parameter
<service-id>
To enter dpi-template configuration mode and bind one rule to
dpi-template (sevice 2 policy is bound for this vlan), execute the
following commands:
ZXR10(config)#dpi-template 2
ZXR10(config-dpi-template-2)#bind service 2

Command bind sip-addr

This binds source IP rules in current DPI-template. Command no
can be used to delete this binding.
DPI-template configuration mode with prompt to be
dpi-template-n)#
bind sip-addr <ip-address><net-mask> service <service-id >
no bind sip-addr <ip-address><net-mask>
Description
It is the slot number where DPI card locates,
ranging from 1 to 12.
Description
It is the id of service entry, ranging from 1
to 2047.
ZXR10(config-
ZXR10(config-