Command Bind Flow-Pool; Command Action; Command Aging-Time - Zte ZXR10 8900 Series Command Manual

Command
Function
Command Mode
Command Format
Parameter
Description
Example
Command
Function
Command Mode
Command Format
Parameter
Description
Example
Command
Function

Command bind flow-pool

This binds flow-pool with current subservice. Command no can be
used to delete this binding.
Subservice configuration mode with prompt to be
service-n)#
bind flow-pool <flow-pool-id>
no bind flow-pool
Parameter
<flow-pool-id>
To enter subservice configuration mode and bind flow-pool 12 with
subservice 2, execute the following commands:
ZXR10(config-dpi)#subservice 2
ZXR10(config-dpi-subservice-2)#bind flow-pool 12

Command action

This sets policy for current subservice.
Subservice configuration mode with prompt to be
.
subservice-n)#
action {permit|deny}
Parameter
{permit|deny}
To enter subservice configuration mode and set permit policy for
subservice 2, execute the following commands:
ZXR10(config-dpi)# subservice 2
ZXR10(config-dpi-subservice-2)#action permit

Command aging-time

This sets aging time for current subservice.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 5 Configuring Sub Service
Description
It is id of flow pool entry, ranging from 2 to
8191.
Description
Policy is permit or deny, where permit
means allowing flow to pass and deny means
forbidding flow passing and then dropping
the packets.
ZXR10(config-sub-
ZXR10(config-dpi-
21