Command Default-Flow-Pool; Command Show Flow-Pool - Zte ZXR10 8900 Series Command Manual

Command
Function
Command Mode
Command Format
Parameter
Description
Example
Command
Function
Command Mode
Command Format
Parameter
Description
Example
Command default-flow-p
ool
This configures parameters upstream and downstream of default
flow pool (flow pool 1). Command no can be used to clear the
configuration.
Configuration mode with prompt to be
default-flow-pool {downstream | upstream} rate-limit <lim
it-rate> cbs <cbs-bytes> ebs <ebs-bytes>
no default-flow-pool {downstream | upstream }
Parameter
<limit-rate>
<cbs-bytes>
<ebs-bytes>
{downstream |
upstream}
To configure upstream rate-limit of default flow pool to 10kbps, cbs
to 5000byte and ebs to 5000byte, execute the following command.
ZXR10(config-dpi)#default-flow-pool
upstream 10 cbs 5000 ebs 5000

Command show flow-pool

This shows configuration of flow pool.
All modes
show flow-pool <flow-pool-id>
Parameter
<flow-pool-id>
To show configuration of flow pool 2, execute the following com-
mand.
ZXR10(config-dpi)#show flow-pool 2 stream-type
rate-limit(kbps) cbs(bytes)
-----------------------------------------------------
downstream 2000
upstream 2000
-----------------------------------------------------
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 4 Configuring Policy
ZXR10(config-dpi)#
Description
It limits rate, ranging from 10 to 1000000,
in kbps.
It is the number of cbs bytes.
It is the number of ebs bytes.
It deletes default configuration of downstream
or upstream.
Description
It is id of flow pool entry, ranging from 1 to
8191.
ebs(bytes)
10000
10000
10000
10000
17