Magnetic Stripe Reader (Msr); Attaching And Removing The Msr - Motorola MC70 User Manual

Spare Battery LED Charging Indicators
Table 5-3
LED
Off
Slow Blinking Amber
Solid Amber
Fast Blinking Amber

Magnetic Stripe Reader (MSR)

This section describes how to set up and use the snap-on MSR with the EDA. The MSR snaps on to the
bottom of the EDA and removes easily when not in use.
When attached to the EDA, the MSR allows the EDA to capture data from magnetic stripe cards. To download
MSR data capture software, visit http://devzone.symbol.com.

Attaching and Removing the MSR

To attach, slide the MSR onto the bottom of the EDA and secure by snapping the arms into the EDA housing.
Card Reader Slot
MSR Installation
Figure 5-13
To remove the MSR open the arms and pull the MSR from the EDA.
NOTE When attaching a cable with a cup connector through the MSR to charge the device, you cannot swipe
cards.
No spare battery in slot; battery is not charging; battery is not inserted correctly
in the charger; charger is not powered.
Spare battery is charging.
Charging complete.
Charging error.
Accessories5 - 13
Indication