Bluetooth Connection - Motorola MC70 User Manual

6 - 4 MC70 User Guide
Troubleshooting the EDA (Continued)
Table 6-1
Problem
The EDA does not
accept scan input.

Bluetooth Connection

Troubleshooting Bluetooth Connection
Table 6-2
Problem
EDA cannot find any
Bluetooth devices
nearby.
When trying to
connect a Bluetooth
phone and EDA, the
phone thinks a
previously paired
EDA is used.
Cause
Scanning Load a scanning application on the EDA. See the system
application is not administrator.
loaded.
Unreadable bar Ensure the symbol is not defaced.
code.
Distance between Place the EDA within proper scanning range.
exit window and
bar code is
incorrect.
EDA is not Program the EDA to accept the type of bar code being scanned.
programmed for
the bar code.
EDA is not If the EDA does not beep on a good decode, set the application
programmed to to generate a beep on good decode.
generate a beep.
Battery is low. If the scanner stops emitting a laser beam upon a trigger press,
check the battery level. When the battery is low, the scanner
shuts off before the EDA low battery condition notification.
Note: If the scanner is still not reading symbols, contact the
distributor or Symbol Technologies.
Cause
Too far from other Move closer to the other Bluetooth device(s), within a range of
Bluetooth devices. 10 meters.
The Bluetooth Turn on the Bluetooth device(s) to find.
device(s) nearby
are not turned on.
The Bluetooth Set the Bluetooth device(s) to discoverable mode. If needed,
device(s) are not in refer to the device's user documentation for help.
discoverable
mode.
The phone Manually delete the pairing device and name from the phone.
remembers the Refer to the phone's user documentation for instructions.
name and address
of the EDA it last
paired with via the
Bluetooth radio.
Solution
Solution