Charging Temperature; Powering On The Eda; Calibrating The Screen; Checking Battery Status - Motorola MC70 User Manual

1 - 8 MC70 User Guide

Charging Temperature

Charge batteries in temperatures from 0
charging is intelligently controlled by the EDA and the charging accessory in order to ensure safe operation
and optimize long-term battery life.
To accomplish this, for small periods of time, the EDA or accessory alternately enables and disables battery
charging to keep the battery at acceptable temperatures. The EDA or accessory indicates when charging is
disabled due to abnormal temperatures via its LED. See

Powering On the EDA

Press the Power button to turn on the EDA. If the EDA does not power on, reset it. See
page 2-23.
When turning the EDA on for the first time, the Symbol splash screen displays for about a minute as the EDA
initializes its flash file system, then the calibration window appears. Note that these windows also appear upon
cold boot.
NOTE When the EDA powers up after inserting a battery for the first time, the device boots and powers on
automatically.

Calibrating the Screen

To calibrate the screen so the cursor on the touch screen aligns with the tip of the stylus:
Remove the stylus from its holder on the back of the EDA.
1.
Carefully press and briefly hold the tip of stylus on the center of each target that appears on the screen.
2.
Repeat as the target moves around the screen, then tap the screen to continue.
3.

Checking Battery Status

To check the charge status of the main battery or backup battery in the EDA, tap
icon to display the
Power
To save battery power, tap the
o o
C to 40 C (32°F to 104°F). Note that at temperatures above 35
window.
Power
tab and set the EDA to turn off after a specified number of minutes.
Advanced
Table 1-2.
Start
o
C,
Resetting the EDA on
> > >
Settings System