Single Slot Usb/Serial Cradle - Motorola MC70 User Manual

6 - 6 MC70 User Guide

Single Slot USB/Serial Cradle

Troubleshooting the Single Slot USB/Serial Cradle
Table 6-3
Symptom
LEDs do not light
when EDA or spare
battery is inserted.
EDA battery is not
charging.
Spare battery is not
charging.
Possible Cause
Cradle is not Ensure the power cable is connected securely to both the cradle
receiving power. and to AC power.
EDA is not seated Remove and re-insert the EDA into the cradle, ensuring it is
firmly in the cradle. firmly seated.
Spare battery is Remove and re-insert the spare battery into the charging slot,
not seated firmly in ensuring it is firmly seated.
the cradle.
EDA was removed Ensure cradle is receiving power. Ensure EDA is seated
from cradle or correctly. Confirm main battery is charging under
cradle was
Settings
unplugged from mAh) fully charges in less than four hours. The extended
AC power too capacity battery (3800 mAh) fully charges in less than eight
soon. hours.
Battery is faulty. Verify that other batteries charge properly. If so, replace the
faulty battery.
The EDA is not Remove and re-insert the EDA into the cradle, ensuring it is
fully seated in the firmly seated.
cradle.
Ambient Move the cradle to an area where the ambient temperature is
temperature of the between 0
cradle is too warm.
Battery not fully Remove and re-insert the spare battery in the cradle, ensuring
seated in charging it is firmly seated.
slot.
Battery inserted Re-insert the battery so the charging contacts on the battery
incorrectly. align with the contacts on the cradle.
Battery is faulty. Verify that other batteries charge properly. If so, replace the
faulty battery.
Ambient Move the cradle to an area where the ambient temperature is
temperature of the between 0
cradle is too warm.
Action
> > . The standard capacity battery (1900
System Power
o o
C and 35 C.
o o
C and 35 C.
>
Start