Resetting The Eda; Performing A Warm Boot - Motorola MC70 User Manual

Linear bar code
Imager Aiming Pattern: Bar Code Centered
Figure 2-20
Correct
Imager Aiming Pattern: Bar Code Not Centered
Figure 2-21
Pick List Mode with Multiple Bar Codes in Aiming Pattern
Figure 2-22
Release the scan button.
4.
NOTE Imager decoding usually occurs instantaneously. The EDA repeats the steps required to take a digital
picture (image) of a poor or difficult bar code as long as the scan button remains pressed.

Resetting the EDA

There are two reset functions, warm boot and cold boot. A warm boot restarts the EDA by closing all running
programs. A cold boot also restarts the EDA, and also resets the clock. Data saved in flash memory or a
memory card is not lost.
Perform a warm boot first. If the EDA still does not respond, perform a cold boot.

Performing a Warm Boot

Hold down the
Power
Power button.
PDF417 symbol
Symbol
View Finder
(Aiming Pattern)
Correct
Incorrect
button for approximately five seconds. As soon as the EDA starts to boot release the
Using the MC70 2 - 23