Inserting The Eda Into The Trigger Handle; Removing The Eda - Motorola MC70 User Manual

TRG7000 Trigger Handle
The TRG7000 Trigger Handle pistol grip accessory adds a gun-style handle with a scanning trigger to the EDA.
It increases comfort when using the EDA in scan-intensive applications for extended periods of time. The
TRG7000 is intended for use with MC70 WLAN/PAN configurations.
Install the cleat onto the EDA before using the trigger handle. For cleat installation and communication setup
procedures refer to the MC70 Integrator Guide.

Inserting the EDA into the Trigger Handle

Slide the EDA into the Trigger Handle until it locks in place. The release secures the EDA to the Trigger
Handle.
Inserting the EDA into the Trigger Handle
Figure 5-15

Removing the EDA

To remove the EDA, press the release down and pull the EDA forward.
Release
Removing the EDA
Figure 5-16
Release
Accessories5 - 15