Troubleshooting the Trigger Handle
Table 6-9
Problem
EDA battery does not
Trigger Handle is
charge when Trigger
not properly
Handle is placed in a
seated in the
cradle.
cradle.
Power is not
available to the
cradle.
Cannot print to
Printer cable not
printer.
connected
properly.
EDA does not wake
The trigger only
from suspend mode
wakes the EDA
when trigger is
from the suspend
pressed.
mode if a scanning
application is
active.
Cause
Remove the Trigger Handle from the cradle and reinsert.
Ensure that power connections to the cradle are connected
properly.
Ensure cable is connected properly to the printer and Trigger
Handle.
Press a key on the EDA to wake from the suspend mode.
Maintenance & Troubleshooting 6 - 13
Solution