Installing Inserts Into The Spindle Rack - Labconco 44000 Series User Manual

Chapter 6: Modifying Your Washer
68
Chapter 2: Prerequisites
C. Adjust the rubber diaphragm
The rubber diaphragm, that is on the upper supply tube
assembly installed in Step A, should almost touch the
lower portion of the hub in the upper spindle rack when
both racks are inside the washer. The diaphragm should
not interfere with the hub when either rack is pulled out.
1. Loosen the clamp at the bottom of the diaphragm
Pif necessaryQ by pressing the clamping surfaces
sideways.
2. Raise or lower the diaphragm as needed.
3. Reinstall the clamp securely by squeezing the two
halves together.
When the Upper Spindle Rack is in place, it limits the
height of the glassware that can be washed. If very tall
glassware or long pipets are to be washed, remove the
Upper Spindle Rack and replace the plug in the center of
the hub on the lower spindle rack.
Installing Insert into the Spindle
Rack
A Multi-Pin insert is available that can be placed directly
on the FlaskScrubber spindle rack that can hold beakers or
wide mouth glassware. The insert can be positioned either
on the left side, right side or front.
To install an insert
1. Remove all glassware, spring retainers and glassware
holders.
2. Lower the insert down over the spindle making sure
that the two alignment pins enter the two holes in the
rack. If necessary, spindles may be removed using a
screwdriver in the slot on the top of the spindles. Be
sure to replace any removed spindle with a plug
supplied with the washer.
P#o%&ct Se#+ice -./00.122.341/