Loading Glassware Into The Flaskscrubber - Labconco 44000 Series User Manual

Chapter 4: Using Your Washer
42
Chapter 2: Prerequisites
IF THE MULTI-PIN INSERT IS
☞
INSTALLED ON THE BOTTOM RACh
AND THE OPTIONAL UPPER RACh IS
USED, DO NOT HEAVILY LOAD THE
MULTI-PIN INSERT WITH WIDE
MOUTH 5LASSWARE. THIS MAY
RESTRICT WATER FLOW FROM THE
LOWER DISTRIBUTION ARM TO THE
5LASSWARE IN THE UPPER RACh.
Loading Glassware into the
FlaskScrubber
To load glassware onto a spindle, place the glassware on
the spindle and adjust the position by raising or lowering
the spring clip, as shown in Figure 4-4. The outlet of the
spindle should be as close to the center of the flask as
possible. Do not allow the glassware to rest on the tip of
the spindle.
Figure 4-4
Squeeze the spring clip
together and raise or
lower the clip to position
the glassware properly.
P#o%&ct Se#+ice -./00.122.341/