Cleaning The Sump Filter Screen - Labconco 44000 Series User Manual

Chapter 5: Maintaining Your Washer
Refer to Figure 4-1 in
Chapter 4: Using Your
Washer for an illustration
of the SteamScrubber
wash arm and tower.
Lower wash arm
Filter screen screw and clip
58
Chapter 2: Prerequisites
Cleaning the Sump Filter
Screen
If debris accumulates on the filter screen that is located in
the washer sump, you can remove and clean the screen.
To clean the sump filter screen, refer to Figure 5-5 and
follow the instructions below.
To clean the sump filter screen:
1. Open the washer door and remove the bottom rack.
2. If you have a SteamScrubber, remove the upper wash
arm. Depress the button on the wash arm tower and
lift the upper portion of the tower to remove the wash
arm. If you have a FlaskScubber, remove the plastic
clamp and rubber diaphragm from the wash tower, as
illustrated in Figure 5-5.
3. Lift and rotate the lower wash arm.
4. Remove the screw and clip at the rear of the filter
screen.
5. Carefully lift the screen, using care not to drop debris
into the pump.
Figure 5-5
P#o%&ct Se#+ice -./00.122.341/
Rubber diaphragm
Plastic clamp