Attaching The Hose-End Coupling; Connecting The Drain Hose - Labconco 44000 Series User Manual

An aerator adapter and a standard-size adapter fitting are
provided with your Mobile washer. If the adapter fitting
provided does not allow for a tight connection to your
faucet, a variety of internally and externally threaded
fittings are available at your local hardware store. Use
caution when installing the fittings to prevent stripping the
threads.
Att6c7ing t7e :o;e.En%
Co&>ling
After you have installed the faucet adapter, the hose-end
coupling of your washer Pshown in Figure 3-12Q attaches
and seals to the aerator adapter by pushing the parts
together. The hose-end coupling must be snapped into
place BEFORE turning on the hot water faucet. Turn the
hot water on SLOWLY until the faucet is completely
open.

Connecting the Drain Hose

Before continuing with this section, be certain that your
drain meets the requirements detailed in Drain
Requirements in Chapter 2: Prerequisites. The washer
drain hose is connected to a fitting on the rear side of the
pumpbmotor assembly.
BE CERTAIN YOU CONFORM TO ALL
☞
LOCAL PLUMBIN5 CODES WHEN
YOU ROUTE AND CONNECT THE
DRAIN.
The drain hose is installed at the factory. The hose
provides a flexible coupling to the drain piping and can be
secured with a spring or band hose clamp. PA band hose
clamp is provided with your washer.Q
P#o%&ct Se#+ice -./00.122.341/
Chapter 3: Getting Started
U F
U F
27