Removing The Shipping Skid; Setting Up Your Washer - Labconco 44000 Series User Manual

Catalog H Washer Description
44204-00 FlaskScrubber Freestanding i 115 V
44204-01 FlaskScrubber Freestanding i 230 V
44204-10 FlaskScrubber Freestanding i 115 V with window
44204-11 FlaskScrubber Freestanding i 230 V with window
Plus the Following:
Part H Component Description
18798-01 Four P4Q Leveling Feet
45036-00 User Manual
44680-00 One P1Q Hole Plug
14888-00 One P1Q Clamp
44222-00 Six P6Q ounces of LabSolutions Powder Detergent Pwith MSDSQ
45221-00 Eight P8Q ounces of LabSolutions Liquid Detergent Pwith MSDSQ
45223-00 Four P4Q ounces of LabSolutions Neutralizing Acid Rinse Pwith
MSDSQ
14201-02 Elbow P1Q
If you did not receive one or more of the components
listed for your washer, or if any of the components are
damaged, contact Labconco Corporation immediately for
further instructions.

Removing the Shipping Skid

After you verify the washer components, move your
washer to the location where you want to install it. Then,
follow the steps listed below to remove the shipping skid
from your washer.
To remove the shipping skid:
1. Make certain any loose items inside the washer have
been removed.
2. 5ently place the washer on its back, positioning the
washer on the shipping carton or other cushioning
material.
3. Remove the four screws fastening the skid to the
washer.

Setting Up Your Washer

After you remove the skid from your washer, you must
install either casters or leveling feet on the bottom of the
washer. If you have an Undercounter or Freestanding
P#o%&ct Se#+ice -./00.122.341/
Chapter 3: Getting Started
FlaskScrubber
Freestanding
Models
Move the washer by
placing a flat, low dolly
under the shipping skid.
Retain the shipping skid
until you test the various
features of the washer.
15