Chapter 3: Getting Started
Drain trap
U
F
U
F
30
Chapter 2: Prerequisites
If you route the drain piping to a floor drain, refer to
Figure 3-15 for placement of the drain tubing and trap.
Connecting the Power Supply
Before continuing with this section, be certain your power
supply meets the requirements specified in Electrical
Requirements in Chapter 2: Prerequisites
and Freestanding Washers should be hard-wired directly
into a junction box. Refer to Figure 3-16 and follow the
steps below to connect your washer to the appropriate
power source.
BE CERTAIN THAT YOU CHECh AND
☞
CONFORM TO ALL LOCAL
ELECTRICAL CODES. DO NOT
DISTURB ANY INTERNAL WIRIN5 IN
THE WASHER.
Figure 3-15
Undercounter
.
P#o%&ct Se#+ice -./00.122.341/