Installing Pipet Inserts In A Flaskscrubber - Labconco 44000 Series User Manual

Installing Pipet Inserts in a
FlaskScrubber
Two sizes of Pipet Inserts are available. The 8-place Pipet
Insert, shown in Figure 6-2 accommodates 1 ml to 10 ml
pipets. Multiple Pipet Inserts may be installed, if desired.
Refer to Figure 6-2 and follow the instructions below to
install an 8-place Pipet Insert.
To install an 8-place Pipet Insert:
1. Insert a screwdriver into the top of any r" spindle and
turn counterclockwise to remove the spindle. Small
spindles may be removed by hand.
2. In the position previously occupied by the spindle,
thread into place the short spindle you received with
the Pipet Insert.
3. Push the Pipet Insert over the short spindle.
P#o%&ct Se#+ice -./00.122.341/
Chapter 6: Modifying Your Washer
Figure 6-2
Pipet holder
Loosen set screw to slide
pipet holder to various
positionsd tighten to secure
in place.
8-place Pipet Insert
Short spindle provided
with Pipet Insert.
Spindle rack
61