Connecting The Hose-End Coupling; Running The Diagnostics - Labconco 44000 Series User Manual

Connecting the Hose-End
Coupling
If you purchased a Mobile 5lassware Washer, the first
action you must take is to connect the hose-end coupling
to the hot water faucet. Snap the hose-end coupling onto
the aerator adapter on the faucet by pushing the parts
together, as shown previously in Figure 3-12. After the
hose-end coupling is attached to the faucet, slowly turn on
the hot water faucet.

Running the Diagnostics

To ensure your washer is operating properly, it is
recommended that you perform the diagnostics procedure
detailed below, which should take approximately 10
minutes to complete. Refer to Figure 3-17 to familiarize
yourself with the control panel before you begin the
procedure.
P#o%&ct Se#+ice -./00.122.341/
Chapter 3: Getting Started
M
M
Figure 3-17
The Scientific
wash cycle is
selected. The
wash will run a
total of 108
minutes, with a
40 minute
drying time.
33