Installing The Adjustable-Height Upper Rack - Labconco 44000 Series User Manual

Installing the Optional
Adjustable-Height Upper Rack
An optional top rack, shown in Figure 6-6, is available to
increase the capacity of the FlaskScrubber to handle wide-
mouth glassware, including beakers. To install the
optional top rack, refer to Figures 6-4 and 6-5 and follow
the instructions below.
To install the optional upper rack:
1. Remove all of the parts from the carton. See Appendix
D for a list of parts shipped.
2. Use a 3b8" hex wrench to remove the black plug in the
center of the spindle rack and replace with the 1b2" to
3b8" bushing.
3. If the rack is to be located in the upper position, thread
in the hub-adapter assembly that you received with the
rack Psee Figure 6-4Q. If the rack is to be located in the
lower position, Psee Figure 6-4AQ, remove the nozzle
from the hub-adapter assembly and thread it into the
bushing.
P#o%&ct Se#+ice -./00.122.341/
Chapter 6: Modifying Your Washer
Figure 6-4
Nozzle
Adapter
Bushing
63