Electrical Requirements - Labconco 44000 Series User Manual

a male e" - 11-1b2 NH hose coupling. A rigid plastic, tin-
lined, or stainless steel tubing and fitting can be connected
to the washer fitting.
All connections on the purified water
!
system must be airtight so that the
washer pump is not allowed to pull air
instead of water.
If the purified water is stored in a carboy, at least 5.8
gallons P22 litersQ must be available for each wash cycle.
If all 5.8 gallons are not available at the start of a wash
cycle, but instead are produced concurrently with the wash
cycle, the production rate must permit at least 1.25 gallons
P4.7 litersQ per minute to be delivered to the washer. In
addition, all 5.8 gallons P22 litersQ must be made available
over a 5-minute period.

Electrical Requirements

If your 5lassware Washer is an Undercounter or
Freestanding model, it should be hard-wired directly into a
junction box using conduit. A 20 Amp circuit breaker or
fuse is required for models rated at 115V P60 HzQ or 230V
P50b60 HzQ.
If your 5lassware Washer is a Mobile model, a dedicated
electrical outlet is required. A 20 Amp circuit breaker or
fuse is required for models rated at 115V P60 HzQ or 230V
P50b60 HzQ. 115V models are equipped with a 20 Amp
NEMA 5-20P plug. 230V models are equipped with a 15
Amp NEMA 6-15P plug. It may be necessary to remove
the plug and install a different plug to match the available
receptacle.
P#o%&ct Se#+ice -./00.122.341/
Chapter 2: Prerequisites
U F
U F
M
7