Filling The Neutralizing Acid Dispenser - Labconco 44000 Series User Manual

Chapter 4: Using Your Washer
Store detergent in a
cool, dry place.
Immediately replace
the detergent con-
tainer lid after
dispensing. If lumps
develop due to
exposure to moisture,
discard the detergent
according to local
regulations.
46
Chapter 2: Prerequisites
Fill the main detergent cavity three-fourths full if the water
hardness grains per gallon P5P5Q for your water measures
0 i 4 5P5 Psoft waterQ. Fill the detergent cavity
completely if your water measures 4 5P5 or higher
Pmedium to hard waterQ. If you use the pre-wash cavity
stamped in the washer door, fill it completely.
To open the detergent dispenser, gently
!
slide the white tab sideways. If the tab is
pulled upward or perpendicular to the
door, it will break.
Filling the Neutralizing Acid
Dispenser
If it is necessary to neutralize the alkalinity of the
detergent, a mild or weak acid may be placed in the
detergent cup neutralizing dispenser from which it will be
dispensed during the first rinse. If pure water rinse is
selected, the last two rinses will be made with pure water.
To avoid dispensing neutralizing acid during a pure rinse,
more than two rinses should be selected. The dispenser
holds approximately 170 ml and should be checked and
replenished as needed. To fill the neutralizing acid
dispenser, refer to Figure 4-6 and follow the instructions
below.
To fill the neutralizing acid dispenser:
1. Twist and pull up on the cap to remove the round cover
on the neutralizing solution port.
2. Fill the cavity with LabSolutions Neutralizing Acid
Rinse, part number 45222-00, 1M citric acid or 10q
phosphoric acid until the level of the liquid rises and is
visible in the port.
3. Set the dial to read 4 ml.
4. Replace the cover.
P#o%&ct Se#+ice -./00.122.341/