Connecting The Water Supplies; Connecting The Hot Water - Labconco 44000 Series User Manual

Connecting the Water
Supplies
A hot water supply must be attached to your 5lassware
Washer. If you need purified water for the final rinse
cycle, then you must also connect a purified water source
to your washer.

Connecting the Hot Water

To prevent valve clogging, flush all of the hot water lines
for your hot water supply source prior to connecting the
washer to the water lines. The water supply valve to
which the hot water supply must be connected is located in
the lower right front corner of the washer. The lower
panel of the washer must be removed to access the valve.
To remove the panel, refer to Figure 3-7 and the
instructions below.
To remove the lower panel:
1. Remove the two screws at the bottom of the lower
panel of your washer.
2. Remove the panel by lifting slightly and pulling out.
P#o%&ct Se#+ice -./00.122.341/
Chapter 3: Getting Started
Figure 3-7
Lift the panel slightly
before pulling out to
disengage the panel
jlip.k
Screw
U F
U F
Before continuing with
this section, be certain
your hot water source
meets the requirements
discussed in Hot Water
Requirements in
Chapter 2:
Prerequisites.
21