Connecting The Purified Water Supply - Labconco 44000 Series User Manual

Connecting the Purified Water
Supply
To prevent valve and pump clogging, flush all of the water
lines for your purified water supply source prior to
connecting the washer to the water lines. The water
supply valve to which the purified water supply must be
connected is located in the lower right front corner of the
washer. The lower panel of the washer must be removed
to access the valve. Refer to Figure 3-9 and follow the
instructions below to connect the purified water source.
THE PURIFIED WATER INLET VALVE
☞
IS EQUIPPED WITH A PLASTIC HOSE
BARB CONNECTION TO ACCOM-
MODATE 3b8" P9.5 MMQ ID FLEnIBLE
PLASTIC OR RUBBER HOSE. THE
HOSE CONNECTION MAY BE
REMOVED FROM THE VALVE TO
EnPOSE A MALE 3b4" - 11-1b2 NH
HOSE COUPLIN5. RI5ID PLASTIC,
TIN-LINED, OR STAINLESS STEEL
TUBIN5 AND FITTIN5S MAY BE
CONNECTED TO THE WASHER
FITTIN5.
P#o%&ct Se#+ice -./00.122.341/
Chapter 3: Getting Started
Before continuing with this
section, be certain your
purified water source meets
the requirements discussed
in Purified Water
Requirements in Chapter 2:
Prerequisites.
Figure 3-9
Customer-
supplied
plumbing
Hose barb
connector
supplied with
washer
Purified
water
valve
23