Installation - Rinnai Advance Operation And Installation Manual

Installation

Unpacking the Appliance and Associated Accessories
Unpack the appliance and check for damage. If damaged contact your supplier for advice. do
not install a damaged appliance.
Before installing, check the label for correct gas type and that you
have all the components you need, refer checklist on page 23).
Before using this appliance, please read this manual to ensure correct use. Failure to follow
these instructions could cause a malfunction of the appliance. This could result in death,
serious bodily injury and/or property damage. Failure to follow these instructions may also
void your fire insurance and/or warranty.
Compliance with
Local Regulations
Power Cord
Gas Consumption
Ventilation
Gas Cylinder
Floor Protection
Supervision
Required
Painting and Dusty
Environments
Flueing
Rinnai New Zealand
The appliance must be installed in accordance with local gas and
electrical authority regulations.
Appliance must not be located below a power socket outlet. Local gas
and electrical authorities will be able to advise on local regulations. If the
supply cord is damaged or requires replacing, it must be replaced by an
authorised person. This must be a genuine replacement part available
from Rinnai.
30-11MJ/h (high to low)
Ensure that the area in which the appliance is installed has adequate
ventilation. This ventilation must be provided as per NZS 5261:2003
2.6.6.
do not connect to an LPG/Propane gas cylinder indoors.
Heat emanating from the front of this fire may over time affect the
appearance of some materials used for flooring such as carpet, vinyl,
cork or timber. This may be amplified if the air in the room contains
cooking vapours or cigarette smoke. To avoid this occurring, it is
recommended that a mat be placed in front of the appliance.
The appliance is not intended for use by young children or infirm persons
without supervision. young children should be supervised to ensure they
do not play with the appliance.
do not operate/install this appliance in places where painting is taking
place, or in places such as hair dressing salons, where there may be a lot
of dust and 'fluff', and where aerosols are used.
A gas appliance must not be connected to a chimney flue serving as a
separate solid-fuel burning appliance.
For installations into new (decorative) fireplaces a Rinnai Zero Clearance
Box and Zero Clearance Flue Kit is required. Failure to meet this criteria
will void any product warranty.
For existing masonry installations, to ensure adequate draw of the
appliance, Rinnai strongly recommends the use of a Rinnai Flexiliner Flue
system. Failure to meet this criteria may result in an unsafe situation.
Installation without a flexiliner flue is permissible as long as the chimney
is checked for soundness and ability to achieve a good draw.
7
Gas type label
is displayed on
the appliance
Reflection: 03-08