Rinnai Advance Operation And Installation Manual page 25

Installation Procedure
Slide Heater into Fireplace
To do this remove the screws holding the trims in place. For the lower
Remove Top and
Lower Trims trim exercise care when removing as you will need to remove the control
to Expose Gas receiver board from the holder.
Connection
Attach Flexi-tube
to Gas Pipe
Slide Heater into do this carefully without forcing, while feeding the stainless steel flexi-tube
Position through the supply access opening. Sometimes the connection can catch
on the back of the fire, if this occurs either use a long drill bit, thread into
the gas pipe from the front to pull through and/or remove the plates above
and below for easier access to the gas connection coming through.
Flue Protector A spring loaded flue protector plate is fitted to prevent the entry of foreign
Plate objects for a masonry chimney installation. If a flexiliner flue system is
not used the plate will fold down as the heater slides through the fireplace
opening.
Make sure that it is not restricted and returns to its normal position when
the heater is installed. If the fire has to be removed, the plate will pivot
backwards to allow the heater to slide clear.
When a flexiliner flue system or Zero Clearance Box is used, the flue
protector plate must be unscrewed and removed.
Once the heater is sitting flat secure via the pre-drilled holes in the heater
surround.
Secure Heater to If using a Zero Clearance Box (ZCB), ensure inner holes of heater
mounting brackets align with the holes on the ZCB. The outer holes are for
the Fireplace
fixing the frame to the ZCB.
For a masonry fixing, measure and
drill 4 holes in the fireplace and insert
wall plugs to secure backing plate and
spacer to the fireplace.
Rinnai New Zealand
Gas connection
25
Backing Plate sits
inside the back rim
of the spacer
Reflection: 03-08