Rinnai Advance Operation And Installation Manual page 11

ETR Operation
Remote Control continued
Important points:
• Some fluorescent lights may interfere with the transmission of remote control signals,
changing the position from which you are operating the remote may help
• Avoid dropping the remote or getting it wet
• Remote control works within five metres of the receiver from the heater
• Remove battery if control is not going to be used for a long period, this will help avoid
damage from leaking batteries.
If the 'Timer(s)' have been selected, and the heater is in standby mode, and the 'OFF' button on the remote
control is pressed, the 'Timer(s)' will be deactivated.
Batteries are supplied with the remote when ordered with the fire. If purchasing the remote as an additional
accessory batteries are not included.
Setting the Clock
Example, setting the clock to 10:35am
1. Press the 'Set Times' button once, the 'Clock' indicator will flash
2. Press and hold the
change by whole hours
3. Release the button when the AM 10:00 shows on the digital display. Confirm that you have
selected 'AM', a small indicator on the left hand side of the digital display indicates the 'AM'
setting.
4. Press and hold down the
go past 'AM' then the
5. Press the 'Set Timer' button five times to lock in and complete setting the time. The 'Clock'
and 'Timer' indicators will go out. A small indicator on the digital display will flash to show
that the clock is operating.
When the appliance is plugged in or after a power failure, the digital display will show --:--
Programming the ON / OFF Timers
Before programming the Timers you must ensure that the clock has been set to the correct
time.
Example, 'Timer 1' to heat the room by 7:10am and finish at 9:00am
1. Press the 'Set Times' button twice, the digital display will show AM 6:00, 'Timer 1' indicator
will flash
2. Press the button until AM 7:00 appears, release the button, then press it again until AM
7:10 appears (press the
3. Press the 'Set Times' button again, the 'Timer 1' off indicator will flash. Press the
until AM 9:00 appears (press the
4. Press the 'Set Times' button three times to lock in the program time, a small indicator on
the digital display will flash to show that the display has returned to the clock.
'Timer 2' is programmed in the same way. Remember to ensure that the 'Timer 2' indicator is flashing when
you program in the desired setting. The timers can be programmed to operate for any two periods within
twenty four hours.
Rinnai New Zealand
button; the minutes will begin to change first, then the time will
button again, release the button when AM 10:35 shows. If you
button can be used to change the settings in reverse.
button if you go past AM 7:10)
button if you go past AM 9:00)

button
Reflection: 03-08