Appliance Location - Rinnai Advance Operation And Installation Manual

Appliance Location

General
When positioning the unit the main points governing location are flueing and warm air
distribution.
This heater must not be installed where curtains or other combustible materials could come
into contact with the appliance. In some cases curtains may need restraining.
Enclosure Requirements
The heater must be positioned on a flat and level surface that allows free movement of the
appliance.
• Masonry Installations, use a slurry of sand and cement to level base as required
• decorative Fireplace, if the heater is elevated the Zero Clearance Box needs to be
supported, either construct a base using board with supporting joists as shown or support
with the frame itself
Enclosure Dimensions
MASONRy INSTALLATION
W-Width 590-790mm
H-Height 585mm
d-depth 410mm
All dimensions provided are critical to the installation of this appliance
and must be adhered to.
Elevate
The Reflection Elevate is designed for up-wall decorative installations and has
Installations a frame of 4 sides. To ensure you get the desired look or if floor mounting,
remember to allow for these frame dimensions when determining positioning
of the enclosure to ensure adequate clearance.
A functional height is 400mm from the floor to the bottom of the Zero
Clearance Box is recommended. When integrating a floating hearth, this
clearance can be stretched to 600mm. The Reflection range has a top air
discharge so this needs to be factored when installing.
Rinnai New Zealand
dECORATIVE FIREPLACE
700-720mm
735mm
600mm
17
supporting joists
Reflection: 03-08