Rinnai Advance Operation And Installation Manual page 28

Installing the Frame, Trims and dress Guard
Installing the Frame
Hang the top of the frame over the angled metal
lip of the fire body, frame should slot into place
as shown.
Installing the Trims
Attach trims to large circular magnets on either
side of the heater.
If installing the dress-guard ensure the holes on
the trims face inwards, these are used to secure
the guard to the heater.
If a dress-guard is not being used, the holes
should face in towards the frame so they can't
be seen. To remove pry trims from the lower
edge closest to the inside of the fire.
Installing the dress Guard
Position trims either side of the dress guard and using the four self tapping screws provided,
fasten the trims to the dress guard.
The top of the dress guard can be identified because it has a narrower section of frame, and
once assembled, the top of the frame should align with the top of the trim.
Position assembled dress guard onto the magnets, being careful not to scratch the glass front.
For cleaning and servicing, the dress guard can be removed by pulling it outward from the
bottom.
Top
Rinnai New Zealand
4 x self tapping
screws (included)
Bottom
Panel trim inner
dress guard
fixing holes
28
Holes face
inwards if a
dress guard is
being fitted
TOP
BOTTOM
Narrow side of frame
Reflection: 03-08