System Configuration; Hardware Configuration - Denso WAVE BHT-805BWB User Manual

BHT-805BWB

1.1 System Configuration

This section describes the hardware required for the barcode data collection system used by the BHT and the BHT
software.

1.1.1 Hardware Configuration

In addition to the BHT, the following hardware and software are required for the barcode data collection
system used by the BHT.
Please note that certain components of the required hardware will differ depending on the type of
communication used.
• Host computer
• CU-800 Series (option): Optical communication unit
• Connection cable (option): Used to connect the BHT and host computer.
• Bluetooth
®
• Software: BHT-BASIC 4.0 Development Pack (Option) and BHT-BASIC 4.0 Transfer Utility (Option)
(2) Wireless LAN
communication
● : Required for system configuration
(1) Infrared communication
(2) Wireless LAN
communication
®
(3)
Bluetooth wireless
communication
*1: When the host computer is equipped with the Bluetooth® wireless communication device.
*2: The BHT supports the following profiles.
・Generic Access Profile
・Serial Port Profile
・Dialup Networking Profile
2
compatible device (Option)
BHT
CU (option)
Wireless LAN access point (option)
Host
BHT
computer
● ●
● ●
● *1 ● *2
®
(3)Bluetooth wireless
communication
(1) Infrared
communication
Wireless LAN Bluetooth
CU
access point
compatible device
● —
— ●
— —
®
compatible device
Bluetooth
(Option)
®
(3) Bluetooth wireless
communication
Host computer
BHT-BASIC 4.0
Development Pack
(Option)
BHT-BASIC 4.0
Transfer Utility
(Option)
®
Software Ref. Page
—
● Page 174
—
● Page 176
●
● Page 179